Topic: Tiltviewer does not load completely

Hello,
I am using TiltViewer, and sometimes it does not load completely, for example it shows 3 images out of 6.   I changed the amount of images but it still happens.  As it happens sometimes I do not know what is the reason,,
If you have experience about it please tell me how can i fix it? TNX

http://i55.tinypic.com/e12rb.jpg

Re: Tiltviewer does not load completely

Check that the paths to the images are correct in the XML file.
If the paths are relative, then they should be relative to the HTML page into which TiltViewer is embedded.
Also check that the filenames and file extensions of the images themselves match the corresponding entries in the XML file with regard to uppercase vs lowercase. Your web server may be case-sensitive and 'image.jpg' is not the same as 'image.JPG'.
If you continue to experience difficulties, please post the URL to your gallery so that I can take a look.

Steven Speirs
SimpleViewer Support Team.

Re: Tiltviewer does not load completely

Thank you for your respond, as I said this problem happens occasionally, for example in my computer it loads fine, but in the other computer just half of it loads.  If I refresh the browser, it load correctly.  So I do not think it is related to the file name because if it was wrong it would not load at all.

Re: Tiltviewer does not load completely

On the computer in which the gallery does not fully load, make sure that the browser and Adobe Flash Player are up-to-date.
You can find the Flash Player version that your browser is running by visiting this page: http://kb2.adobe.com/cps/155/tn_15507.html

Steven Speirs
SimpleViewer Support Team.

Re: Tiltviewer does not load completely

I think the problem is related to browser or the plash player as you mentioned before.  I shared my question here just to know if anyone have the same problem.
TNX for your responds.